Unofficial forum about mPrinter.

Home » Other » Unsorted » mPrinter Technical Detail (Technical Detail (print protocol, &c))
mPrinter Technical Detail [message #144] Sun, 18 May 2014 00:01
swbuehler is currently offline  swbuehler
Messages: 4
Registered: May 2014
Location: Tampa, FL
Junior Member
After looking through the sample C code that Adam put up a while back on Github, I was able to find out the following:

Print format: Raster, raw code is Hex 1B, 2A, 72, 45, 00, 00, [72 bytes of binary raster], 00 (ASCII: [ESC] * r E [NUL] [NUL] <72 bytes> [NUL]).

Adam's Objective-C code dithers input using the Floyd-Steinberg dither to 1-bit raster.

USB Interface:

Simple HID Device Demo:

Product ID: 0x003f
Vendor ID: 0x04d8 (Microchip Technology Inc.)
Version: 0.02
Speed: Up to 12 Mb/sec
Manufacturer: Microchip Technology Inc.
Location ID: 0x1d131000 / 7
Current Available (mA): 500
Current Required (mA): 100

It doesn't appear to be programmed to actually do anything other than look pretty.
Previous Topic: Need to buy an mPrinter
Goto Forum:

Current Time: Sat Feb 16 10:23:17 CET 2019

Total time taken to generate the page: 0.01688 seconds